IPv6 Commands
387
ProSafe Managed Switch
no auto-cost reference-bandwidth (OSPFv3)
Use this command to set the reference bandwidth to the default value.
Format no auto-cost reference-bandwidth
Mode
clear ipv6 ospf
Use this command to disable and re-enable OSPF.
Format clear ipv6 ospf
Mode
clear ipv6 ospf configuration
Use this command to reset the OSPF configuration to factory defaults.
Format clear ipv6 ospf configuration
Mode
clear ipv6 ospf counters
Use this command to reset global and interface statistics.
Format clear ipv6 ospf counters
Mode
clear ipv6 ospf neighbor
Use this command to drop the adjacency with all OSPF neighbors. On each neighbor’s
interface, send a one-way hello. Adjacencies may then be re-established. To drop all
adjacencies with a specific router ID, specify the neighbor’s Router ID using the optional
parameter [neighbor-id].
Format clear ipv6 ospf neighbor [neighbor-id]
Mode
Format auto-cost reference-bandwidth <1 to 4294967>
Mode
Router OSPFv3 Config
Router OSPFv3 Config
Privileged EXEC
Privileged EXEC
Privileged EXEC
Privileged EXEC
To Next Page
Loading...
