NETGEAR ProSAFE M7100-24X - LLDP-MED Commands; Show Lldp Local-Device Detail

Interface
Port ID
Port
Description
Switching Commands
180
ProSafe Managed Switch
show lldp local-device detail
Use this command to display detailed information about the LLDP data a specific interface
transmits.
Format show lldp local-device detail <unit/slot/port>
Mode
Interface
Chassis ID
Subtype
Chassis ID
Port ID Subtype
Port ID
System Name
System
Description
Port
Description
System
Capabilities
Supported
System
Capabilities
Enabled
Management
Address
LLDP-MED Commands
Link Layer Discovery Protocol - Media Endpoint Discovery (LLDP-MED) (ANSI-TIA-1057)
provides an extension to the LLDP standard. Specifically, LLDP-MED provides extensions for
network configuration and policy, device location, Power over Ethernet (PoE) management
and inventory management.
Term Definition
The interface in a unit/slot/port format.
The port ID associated with this interface.
The port description associated with the interface.
Privileged EXEC
Term Definition
The interface that sends the LLDPDU.
The type of identification used in the Chassis ID field.
The chassis of the local device.
The type of port on the local device.
The port number that transmitted the LLDPDU.
The system name of the local device.
Describes the local system by identifying the system name and versions of hardware,
operating system, and networking software supported in the device.
Describes the port in an alpha-numeric format.
Indicates the primary function(s) of the device.
Shows which of the supported system capabilities are enabled.
The type of address and the specific address the local LLDP agent uses to send and
receive information.