IPv6 Commands
364
ProSafe Managed Switch
show ipv6 interface
Use this command to show the usability status of IPv6 interfaces and whether ICMPv6
Destination Unreachable messages may be sent.
Format show ipv6 interface {brief | <unit/slot/port> |tunnel <0-7> |
loopback <0-7>}
Mode
If you use the brief parameter, the following information displays for all configured IPv6
interfaces:
Interface
IPv6 Routing
Operational
Mode
IPv6
Address/Length
If you specify an interface, the following information also appears.
Privileged EXEC
Term Definition
The interface in unit/slot/port format.
Shows whether the mode is enabled or disabled.
Shows the IPv6 address and length on interfaces with IPv6 enabled.
Term Definition
IPv6 is enabled
Appears if IPv6 is enabled on the interface.
Routing Mode
Shows whether IPv6 routing is enabled or disabled.
Administrative
Mode
Shows whether the interface administrative mode is enabled or disabled.
Bandwidth
Shows bandwidth of the interface.
Interface
Maximum
Transmission
Unit
The MTU size, in bytes.
Router
Duplicate
Address
Detection
Transmits
The number of consecutive duplicate address detection probes to transmit.
Router
Advertisement
NS Interval
The interval, in milliseconds, between router advertisements for advertised neighbor
solicitations.
Router
Advertisement
Lifetime
Shows the router lifetime value of the interface in router advertisements.
Router
Advertisement
Reachable Time
The amount of time, in milliseconds, to consider a neighbor reachable after neighbor
discovery confirmation.
To Next Page
Loading...
Need help?
General