Captive Portal Commands
731
ProSafe Managed Switch
no group
Use this command to reset the group number to the default.
Default 1
Format no group <1-10>
Mode
redirect (Captive Portal)
Use this command to enable the redirect mode for a captive portal configuration. Use the “no”
form of this command to disable redirect mode.
Default disable
Format redirect
Mode
no redirect
Use this command to disable redirect mode.
Format no redirect
Mode
redirect-url
Use this command to configure the redirect URL for a captive portal configuration. The url is
the URL for redirection which can be up to 512 characters in length.
Format redirect-url url
Mode
max-bandwidth-down
Use this command configures the maximum rate at which a client can receive data from the
network. The rate is in bits per seconds. 0 indicates limit not enforced.
Default 0
Format max-bandwidth-down <0-536870911>
Mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode
To Next Page
Loading...
Need help?
General