Captive Portal Commands
730
ProSafe Managed Switch
no name
Use this command to remove a configuration name.
Format no name
Mode
protocol
Use this command to configure the protocol mode for a captive portal configuration. The
default protocol is http.
Default http
Format protocol { http | https }
Mode
verification
Use this command to configure the verification mode for a captive portal configuration. User
verification can be configured to allow access for guest users; users that do not have
assigned user names and passwords. User verification can also be configured to allow
access for authenticated users. Authenticated users are required to enter a valid user name
and password that must first be validated against the local database or a RADIUS server.
Network access is granted once user verification has been confirmed.
Default guest
Format verification { guest | local | radius }
Mode
group
Use this command to configure a group ID for this captive portal configuration. If a group
number is configured, the user entry (Local or RADIUS) must be configured with the same
name and the group to authenticate to this captive portal instance. The group ID must be
assigned first. If it isn’t, use the user group <1-10> command to create the group ID. The
default group ID is 1 for a captive portal configuration.
Default 1
Format group <1-10>
Mode
Format name <cp-name>
Mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode
Captive Portal Instance mode
To Next Page
Loading...
Need help?
General