Switching Commands
94
ProSafe Managed Switch
interface increases beyond the configured threshold, the traffic is dropped. Therefore, the
rate of broadcast traffic is limited to the configured threshold.
Default
Format storm-control broadcast level
<0-100>
Mode
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for an
interface and disables broadcast storm recovery.
Format no storm-control broadcast level
Mode
storm-control broadcast rate
Use this command to configure the broadcast storm recovery threshold for an interface in
packets per second. If the mode is enabled, broadcast storm recovery is active, and if the
rate of L2 broadcast traffic ingressing on an interface increases beyond the configured
threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is limited to the
configured threshold.
Default
Format storm-control broadcast rate <0-14880000>
Mode
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for an
interface and disables broadcast storm recovery.
Format no storm-control broadcast rate
Mode
storm-control broadcast (Global)
This command enables broadcast storm recovery mode for all interfaces. If the mode is
enabled, broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing
on an interface increases beyond the configured threshold, the traffic will be dropped.
Therefore, the rate of broadcast traffic will be limited to the configured threshold.
5
Interface Config
Interface Config
0
Interface Config
Interface Config
Default
disabled
To Next Page
Loading...
Need help?
General