IPv6 Commands
360
ProSafe Managed Switch
no ipv6 nd other-config-flag
This command resets the “other stateful configuration” flag back to its default value in router
advertisements sent from the interface.
Format no ipv6 nd other-config-flag
Mode
ipv6 nd ra-interval
This command sets the transmission interval between router advertisements.
Default
Format ipv6 nd ra-interval-max <4- 1800>
Mode
no ipv6 nd ra-interval
This command sets router advertisement interval to the default.
Format no ipv6 nd ra-interval-max
Mode
ipv6 nd ra-lifetime
This command sets the value, in seconds, that is placed in the Router Lifetime field of the
router advertisements sent from the interface. The <lifetime> value must be zero, or it
must be an integer between the value of the router advertisement transmission interval and
9000. A value of zero means this router is not to be used as the default router.
Default
Format ipv6 nd ra-lifetime <lifetime>
Mode
no ipv6 nd ra-lifetime
This command resets router lifetime to the default value.
Format no ipv6 nd ra-lifetime
Mode
Interface Config
600
Interface Config
Interface Config
1800
Interface Config
Interface Config
To Next Page
Loading...
