NETGEAR ProSAFE M7100-24X - Show Mvr Interface

Multicast VLAN Registration (MVR)
214
ProSafe Managed Switch
The following table describes the output parameters.
Example:
(switch)#show mvr members
MVR Group IP Status Members
------------------ --------------- ---------------------
224.1.1.1 INACTIVE 1/0/1, 1/0/2, 1/0/3
(switch)#show mvr members 224.1.1.1
MVR Group IP Status Members
------------------ --------------- ---------------------
224.1.1.1 INACTIVE 1/0/1, 1/0/2, 1/0/3
show mvr interface
This command displays the MVR-enabled interfaces configuration.
The following table explains the output parameters.
• active or inactive indicates whether the port is forwarding.
• inVLAN or notInVLAN indicates whether the port is part of any VLAN.
Example:
(switch)#show mvr interface
Port Type Status Immediate Leave
--------- --------------- --------------------- --------------------
1/0/9 RECEIVER ACTIVE/inVLAN DISABLED
Term Definition
MVR Group IP MVR group multicast IP address.
Status The status of the specific MVR group. It can be active or inactive.
Members The list of ports that participates in the specified MVR group.
Format show mvr interface [<interface-id > [members [vlan <vid>]] ]
Mode Privileged EXEC
Parameter Description
Port Interface number
Type The MVR port type. It can be none, receiver, or source type.
Status The interface status. It consists of two characteristics:
Immediate Leave The state of immediate mode. It can be enabled or disabled.