NETGEAR ProSAFE M7100-24X - Show Authorization Methods

Management Commands
656
ProSafe Managed Switch
no authorization(console/telnet/ssh)
This command is used to remove command authorization from a line config mode.
Format no authorization {commands| exec}
Mode
• Line console
• Line telnet
• Line SSH
show authorization methods
This command displays the configured authorization method lists.
Format show authorization methods
Mode
Example:
(Switch) #show authorization methods
Command Authorization List Method
---------------------------- ------------------------------
dfltCmdAuthList none undefined undefined undefined
Line Command Method List
--------- ---------------------
Console dfltCmdAuthList
Telnet dfltCmdAuthList
SSH dfltCmdAuthList
Exec Authorization List Method
---------------------------- ------------------------------
dfltExecAuthList none undefined undefined undefined
Line Exec Method List
--------- ---------------------
Console dfltExecAuthList
Telnet dfltExecAuthList
SSH dfltExecAuthList
domain-name
Managed switch supports authentication based on domain name in addition to the username
and password. This command allows the switch to be configured in a domain. Users can
enable or disable domain functionality.
Following are the two cases
• Domain enabled: In this case, when the user enters only the username, then the
managed switch sends the username as the domain-name (configured on
switch)\username to the RADIUS server. If the user enters the domain name and
Privileged EXEC