Switching Commands
53
ProSafe Managed Switch
no vlan protocol group name
This command removes the name from a protocol-based VLAN groups.
Format no vlan protocol group name <1-128>
Mode
vlan protocol group add protocol
This command adds the protocol to the protocol-based VLAN identified by groupid. A group
may have more than one protocol associated with it. Each interface and protocol combination
can only be associated with one group. If adding a protocol to a group causes any conflicts
with interfaces currently associated with the group, this command fails and the protocol is not
added to the group. The possible values for protocol-list includes the keywords ip, arp, and
ipx and hexadecimal or decimal values ranging from 0x0600 (1536) to 0xFFFF (65535). The
protocol list can accept up to 16 protocols separated by a comma.
Default
Format vlan protocol group add protocol <groupid> ethertype
{<protocol-list>|arp|ip|ipx}
Mode
no vlan protocol group add protocol
This command removes the <protocol> from this protocol-based VLAN group that is
identified by this <groupid>. The possible values for protocol are ip, arp, and ipx.
Format no vlan protocol group add protocol <groupid> ethertype
{<protocol-list>|arp|ip|ipx}
Mode
protocol group
This command attaches a <vlanid> to the protocol-based VLAN identified by <groupid>.
A group may only be associated with one VLAN at a time, however the VLAN association can
be changed.
Default
Format protocol group <groupid> <vlanid>
Mode
Global Config
none
Global Config
Global Config
none
VLAN Config
To Next Page
Loading...
Need help?
General