Captive Portal Commands
735
ProSafe Managed Switch
interface (Captive Portal)
Use this command to associate an interface with a captive portal configuration.
Format interface <unit/slot/port>
Mode
no interface
Use this command to remove an association with a captive portal configuration.
Format no interface <unit/slot/port>
Mode
block
Use this command to block all traffic for a captive portal configuration. The administrator can
block access to a captive portal configuration. When an instance is blocked no client traffic is
allowed through any interfaces associated with that captive portal configuration. Blocking a
captive portal instance is a temporary command executed by the administrator and not saved
in the configuration.
Default no block
Format block
Mode
no block
Use this command to unblock traffic.
Format no block
Mode
Captive Portal Status Commands
This section describes commands that return captive portal status.
show captive-portal configuration
Use this command to display the operational status of each captive portal configuration.
Format show captive-portal configuration <1-10>
Mode
Captive Portal Instance Config mode
Captive Portal Instance Config mode
Captive Portal Instance mode
Captive Portal Instance mode
Privileged EXEC mode
To Next Page
Loading...
Need help?
General