NETGEAR ProSAFE M7100-24X - Dos-Control Smacdmac; Dos-Control Tcpport

Switching Commands
194
ProSafe Managed Switch
Request (PING) packets ingress having a size greater than the configured value, the packets
will be dropped if the mode is enabled.
Default
Format dos-control icmp [<0-1023>]
Mode
no dos-control icmp
This command disables Maximum ICMP Packet Size Denial of Service protections.
Format no dos-control icmp
Mode
dos-control smacdmac
This command enables Source MAC address = Destination MAC address (SMAC=DMAC)
Denial of Service protection. If the mode is enabled, Denial of Service prevention is active for
this type of attack. If packets ingress with SMAC=DMAC, the packets will be dropped if the
mode is enabled.
Default
Format dos-control smacdmac
Mode
no dos-control smacdmac
This command disables Source MAC address = Destination MAC address (SMAC=DMAC)
Denial of Service protection.
Format no dos-control smacdmac
Mode
dos-control tcpport
This command enables TCP L4 source = destination port number (Source TCP Port =
Destination TCP Port) Denial of Service protection. If the mode is enabled, Denial of Service
prevention is active for this type of attack. If packets ingress with Source TCP Port =
Destination TCP Port, the packets will be dropped if the mode is enabled.
Default
Format dos-control tcpport
Mode
disabled <512>
Global Config
Global Config
disabled
Global Config
Global Config
disabled
Global Config