IP Multicast Commands
327
ProSafe Managed Switch
show ip dvmrp prune
This command displays the table listing the router’s upstream prune information.
Format show ip dvmrp prune
Modes
• Privileged EXEC
• User EXEC
Group IP
Source IP
Source Mask
Expiry Time
(secs)
show ip dvmrp route
This command displays the multicast routing information for DVMRP.
Format show ip dvmrp route
Modes
• Privileged EXEC
• User EXEC
Source Address
Source Mask
Upstream
Neighbor
Interface
Metric
Expiry Time
(secs)
Up Time (secs)
PIM Commands
This section describes the commands you use to configure Protocol Independent Multicast
(PIM). PIM is a multicast routing protocol that provides scalable inter-domain multicast
Term Definition
The multicast Address that is pruned.
The IP address of the source that has pruned.
The network Mask for the prune source. It should be all 1s or both the prune source and
prune mask must match.
The expiry time in seconds. This is the time remaining for this prune to age out.
Term Definition
The multicast address of the source group.
The IP Mask for the source group.
The IP address of the neighbor which is the source for the packets for a specified
multicast address.
The interface used to receive the packets sent by the sources.
The distance in hops to the source subnet. This field has a different meaning than the
Interface Metric field.
The expiry time in seconds, which is the time left for this route to age out.
The time when a specified route was learnt, in seconds.
To Next Page
Loading...
Need help?
General