Management Commands
664
ProSafe Managed Switch
no snmp-server community mode
Use this command to deactivate an SNMP community. If the community is disabled, no
SNMP requests using this community are accepted. In this case the SNMP manager
associated with this community cannot manage the switch until the Status is changed back to
Enable.
Format no snmp-server community mode <name>
Mode
snmp-server community ro
Use this command to restrict access to switch information. The access mode is read-only
(also called public).
Format snmp-server community ro <name>
Mode
snmp-server community rw
Use this command to restrict access to switch information. The access mode is read/write
(also called private).
Format snmp-server community rw <name>
Mode
snmp-server enable traps violation
Use this command to enable sending new violation traps designating when a packet with a
disallowed MAC address is received on a locked port.
Note: For other port security commands, see Protected Ports Commands
on page 64.
Global Config
Global Config
Global Config
Default
disabled
Format snmp-server enable traps violation
Mode
Interface Config
To Next Page
Loading...
Need help?
General