Switching Commands
130
ProSafe Managed Switch
dhcp client vendor-id-option-string
Use this command to set the DHCP Vendor Option-60 string to be included in requests
transmitted to the DHCP server by the DHCP client operating in the switch.
Format dhcp client vendor-id-option-string <string>
Mode
no dhcp client vendor-id-option-string
Use this command to clear the DHCP Vendor Option-60 string.
Format no dhcp client vendor-id-option-string
Mode
show dhcp client vendor-id-option
Use this command to display the configured administration mode of the vendor-id-option and
the vendor-id string to be included in Option-43 in DHCP requests.
Format show dhcp client vendor-id-option
Mode
Example: The following shows example CLI display output for the command.
(switch) #show dhcp client vendor-id-option
DHCP Client Vendor Identifier Option ........... Enabled
DHCP Client Vendor Identifier Option string .... Client.
DHCP Snooping Configuration Commands
This section describes commands you use to configure DHCP Snooping.
ip dhcp snooping
Use this command to enable DHCP Snooping globally.
Default
Format ip dhcp snooping
Mode
Global Config
Global Config
Privileged EXEC
disabled
Global Config
To Next Page
Loading...
Need help?
General