Switching Commands
151
ProSafe Managed Switch
set igmp mrouter interface
This command configures the interface as a multicast router interface. When configured as a
multicast router interface, the interface is treated as a multicast router interface in all VLANs.
Default
Format set igmp mrouter interface
Mode
no set igmp mrouter interface
This command disables the status of the interface as a statically configured multicast router
interface.
Format no set igmp mrouter interface
Mode
set igmp router-alert-check
This command enables the Router-Alert validation for IGMP snooping packets
Default
Format set igmp router-alert-check
Mode
no set igmp router-alert-check
This command disables the Router-Alert validation for IGMP snooping packets..
Format no set igmp router-alert-check
Mode
set igmp unknow-multicast filter
This command enables the filtering of unknown multicast packets to the VLAN. Packets with
an unknown multicast address in the destination field will be dropped. This command is
mainly used when IGMP snooping is enabled, to prevent flooding of unwanted multicast
packets to every port.
Format set igmp unknow-multicast filter
Mode
disabled
Interface Config
Interface Config
Disabled
Global Config
Global Config
Global Config
To Next Page
Loading...
Need help?
General