Captive Portal Commands
743
ProSafe Managed Switch
If the CP ID is specified, the following terms are displayed.
Interface
Description
Example
(switch)#show captive-portal configuration client status
CP ID CP Name Client MAC Address Client IP Address Interface
----- ------- ------------------ ----------------- ---------
1 cp1 0002.BC00.1290 10.254.96.47 1/0/1
2 cp2 0002.BC00.1292 10.254.96.49 1/0/3
3 cp3 0002.BC00.1293 10.254.96.50 1/0/4
(switch)#show captive-portal configuration 1 client status
CP ID..................................... 1
CP Name................................... cp1
Client Client
MAC Address IP Address Interface Interface Description
-------------- ------------- --------- ----------------------
0002.BC00.1290 10.254.96.47 1/0/1 Unit:1 Slot:0 Port:1 Gigabit
0002.BC00.1291 10.254.96.48 1/0/2 Unit:1 Slot:0 Port:2 Gigabit
captive-portal client deauthenticate
Use this command to deauthenticate a specific captive portal client. The macaddr is
the Client MAC address.
Format captive-portal client deauthenticate [<macaddr>|<1-10>]
Mode
Captive Portal Interface Commands
The following section describes captive portal interface commands.
show captive-portal interface configuration status
Use this command to display the interface to configuration assignments for all captive portal
configurations or for a specific configuration. <1-10> is the captive portal ID.
Format show captive-portal interface configuration [ <1-10>] status
Mode
Term Definition
The description of the interface
Privileged EXEC mode
Privileged EXEC mode
Term Definition
CP ID
The captive portal ID
CP Name
The captive portal name
To Next Page
Loading...
