NETGEAR ProSAFE M7100-24X - Redistribute (Ospfv); Router-ID (Ospfv)

IPv6 Commands
392
ProSafe Managed Switch
no passive-interface(OSPFv3)
Use this command to set the interface or tunnel as non-passive. It overrides the global
passive mode that is currently effective on the interface or tunnel.
Format no passive-interface {<unit/slot/port> | tunnel <tunnel-id>}
Mode
redistribute (OSPFv3)
This command configures the OSPFv3 protocol to allow redistribution of routes from the
specified source protocol/routers.
Default
• metric—unspecified
• type—2
• tag—0
Format redistribute {static | connected} [metric <0-16777214>] [metric-type
{1 | 2}] [tag <0-4294967295>]
Mode
no redistribute(OSPFv3)
This command configures OSPF protocol to prohibit redistribution of routes from the
specified source protocol/routers.
Format no redistribute {static | connected} [metric] [metric-type] [tag]
Mode
router-id (OSPFv3)
This command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id.
The <ipaddress> is a configured value.
Format router-id <ipaddress>
Mode
Router OSPFv3 Config
Router OSPFv3 Config
Router OSPFv3 Config
Router OSPFv3 Config