NETGEAR ProSAFE M7100-24X - Show Ip Igmp-Proxy Groups Detail

IP Multicast Commands
349
ProSafe Managed Switch
Example: The following shows example CLI display output for the command.
(Switch) #show ip igmp-proxy groups
Interface Index................................ 1/0/1
Group Address Last Reporter Up Time Member State Filter Mode Sources
------------- -------------- ---------- ------------- ------------- -------
225.4.4.4 5.5.5.48 00:02:21 DELAY_MEMBER Include 3
226.4.4.4 5.5.5.48 00:02:21 DELAY_MEMBER Include 3
227.4.4.4 5.5.5.48 00:02:21 DELAY_MEMBER Exclude 0
228.4.4.4 5.5.5.48 00:02:21 DELAY_MEMBER Include 3
show ip igmp-proxy groups detail
This command displays complete information about multicast groups that IGMP Proxy
reported. It displays a table of entries with the following as the fields of each column.
Format show ip igmp-proxy groups detail
Modes
• Privileged EXEC
• User EXEC
Filter Mode
Possible values are Include or Exclude.
Sources
The number of sources attached to the multicast group.
Term Definition
Interface
The interface number of the IGMP Proxy.
Group Address
The IP address of the multicast group.
Last Reporter
The IP address of host that last sent a membership report for the current group, on the
network attached to the IGMP-Proxy interface (upstream interface).
Up Time (in
secs)
The time elapsed since last created.
Member State
The status of the entry. Possible values are IDLE_MEMBER or DELAY_MEMBER.
• IDLE_MEMBER - interface has responded to the latest group membership query for
this group.
• DELAY_MEMBER - interface is going to send a group membership report to respond
to a group membership query for this group.
Filter Mode
Possible values are Include or Exclude.
Sources
The number of sources attached to the multicast group.
Term Definition