IPv6 Commands
379
ProSafe Managed Switch
no ipv6 ospf network
This command sets the interface type to the default value.
Format no ipv6 ospf network {broadcast | point-to-point}
Mode
ipv6 ospf priority
This command sets the OSPF priority for the specified router interface. The priority of the
interface is a priority integer from 0 to 255. A value of 0 indicates that the router is not eligible
to become the designated router on this network.
Default
Format ipv6 ospf priority <0-255>
Mode
no ipv6 ospf priority
This command sets the default OSPF priority for the specified router interface.
Format no ipv6 ospf priority
Mode
ipv6 ospf retransmit-interval
This command sets the OSPF retransmit Interval for the specified interface. The retransmit
interval is specified in seconds. The value for <seconds> is the number of seconds between
link-state advertisement retransmissions for adjacencies belonging to this router interface.
This value is also used when retransmitting database description and link-state request
packets. Valid values range from 0 to 3600 (1 hour).
Default
Format ipv6 ospf retransmit-interval
<seconds>
Mode
no ipv6 ospf retransmit-interval
This command sets the default OSPF retransmit Interval for the specified interface.
Format no ipv6 ospf retransmit-interval
Mode
Interface Config
1, which is the highest router priority
Interface Config
Interface Config
5
Interface Config
Interface Config
To Next Page
Loading...
