NETGEAR ProSAFE M7100-24X - Show Ip Igmp-Proxy Groups

IP Multicast Commands
348
ProSafe Managed Switch
Example: The following shows example CLI display output for the command.
(Switch) #show ip igmp-proxy interface
Interface Index................................ 1/0/1
Ver Query Rcvd Report Rcvd Report Sent Leave Rcvd Leave Sent
------------------------------------------------------------------
1 0 0 0 ----- -----
2 0 0 0 0 0
3 0 0 0 ----- -----
show ip igmp-proxy groups
This command displays information about the subscribed multicast groups that IGMP Proxy
reported. It displays a table of entries with the following as the fields of each column.
Format show ip igmp-proxy groups
Modes
• Privileged EXEC
• User EXEC
Term Definition
Ver
The IGMP version.
Query Rcvd
Number of IGMP queries received.
Report Rcvd
Number of IGMP reports received.
Report Sent
Number of IGMP reports sent.
Leaves Rcvd
Number of IGMP leaves received. Valid for version 2 only.
Leaves Sent
Number of IGMP leaves sent on the Proxy interface. Valid for version 2 only.
Term Definition
Interface
The interface number of the IGMP Proxy.
Group Address
The IP address of the multicast group.
Last Reporter
The IP address of host that last sent a membership report for the current group on the
network attached to the IGMP Proxy interface (upstream interface).
Up Time (in
secs)
The time elapsed since last created.
Member State
The status of the entry. Possible values are IDLE_MEMBER or DELAY_MEMBER.
• IDLE_MEMBER - interface has responded to the latest group membership query for
this group.
• DELAY_MEMBER - interface is going to send a group membership report to respond
to a group membership query for this group.