Routing Commands
306
ProSafe Managed Switch
show dampening interface
This command summarizes the number of interfaces configured with dampening and the
number of interfaces being suppressed.
Format
show dampening interface
Mode
The following shows example CLI display output for the command.
(netgear switch)# show dampening interface
2 interfaces are configured with dampening.
1 interface is being suppressed.
show interface dampening
This command displays the status and configured parameters of the interfaces configured
with dampening.
Format
show interface dampening
Mode
Note: The CLI command clear counters resets the flap count to zero.
The interface CLI command no shutdown resets the suppressed
state to False.
Privileged EXEC
Privileged EXEC
Parameter Description
Flaps The number times the link state of an interface changed from UP to DOWN.
Penalty Accumulated Penalty.
Supp Indicates whether the interface is suppressed or not.
ReuseTm Number of seconds until the interface is allowed to come up again.
HalfL Configured half-life period.
ReuseV Configured reuse-threshold.
SuppV Configured suppress threshold.
MaxSTm Configured maximum suppress time in seconds.
MaxPenalty Maximum possible penalty.
Restart Configured restart penalty.
To Next Page
Loading...
Need help?
General