NETGEAR ProSAFE M7100-24X User Manual

Captive Portal Commands
728
ProSafe Managed Switch
Operational Status........................ Disabled
Disable Reason............................ Administrator Disabled
CP IP Address................. 1.2.3.4
show captive-portal status
Use this command to report the status of all captive portal instances in the system.
Format show captive-portal status
Mode
Example
(switch)#show captive-portal status
Additional HTTP Port........................... 0
Additional HTTP Secure Port.................... 0
Peer Switch Statistics Reporting Interval...... 120
Authentication Timeout......................... 300
Supported Captive Portals...................... 10
Configured Captive Portals..................... 1
Active Captive Portals......................... 0
System Supported Users......................... 1024
Local Supported Users.......................... 128
Authenticated Users............................ 0
Privileged EXEC mode
Term Definition
Additional HTTP
Port
The additional HTTP port for captive portal to monitor. Captive portal only monitors port
80 by default.
Additional HTTP
Secure Port
The additional HTTPs port for captive portal to monitor. Captive portal only monitors
port 443 by default.
Peer Switch Statistics Reporting Interval
Authentication
Timeout
The timeout for the authentication page to be served again.
Supported
Captive Portals
The maximum number of captive portal instances supported by switch. It supports up
to 10 instances.
Configured
Captive Portals
The number of created captive portal instances.
Active Captive
Portals
The number of active captive portal instances.
System
Supported Users
The maximum number of user can be authenticated.
Local Supported
Users
The maximum number of local user can be created.
Authenticated
Users
The number of the authenticated users.

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English