NETGEAR ProSAFE M7100-24X - Port Lacptimeout (Global Config); Port-Channel Adminmode

Switching Commands
114
ProSafe Managed Switch
no port lacptimeout
This command sets the timeout back to its default value on a physical interface of a particular
device type (actor or partner).
Format no port lacptimeout {actor | partner}
Mode
port lacptimeout (Global Config)
This command sets the timeout for all interfaces of a particular device type (actor or
partner) to either long or short timeout.
Default
Format port lacptimeout {actor | partner} {long | short}
Mode
no port lacptimeout
This command sets the timeout for all physical interfaces of a particular device type (actor
or partner) back to their default values.
Format no port lacptimeout {actor | partner}
Mode
port-channel adminmode
This command enables a port-channel (LAG). This command sets every configured
port-channel with the same administrative mode setting.
Format port-channel adminmode all
Mode
no port-channel adminmode
This command disables a port-channel (LAG). This command clears every configured
port-channel with the same administrative mode setting.
Format no port-channel adminmode [all]
Mode
Interface Config
long
Global Config
Global Config
Global Config
Global Config