NETGEAR ProSAFE M7100-24X - Dos-Control Tcpoffset; Dos-Control Tcpsyn

Switching Commands
196
ProSafe Managed Switch
no dos-control tcpflagseq
This command sets disables TCP Flag and Sequence Denial of Service protection.
Format no dos-control tcpflagseq
Mode
dos-control tcpoffset
This command enables TCP Offset Denial of Service protection. If the mode is enabled,
Denial of Service prevention is active for this type of attack. If packets ingress having TCP
Header Offset equal to one (1), the packets will be dropped if the mode is enabled.
Default
Format dos-control tcpoffset
Mode
no dos-control tcpoffset
This command disabled TCP Offset Denial of Service protection.
Format no dos-control tcpoffset
Mode
dos-control tcpsyn
This command enables TCP SYN and L4 source = 0-1023 Denial of Service protection. If the
mode is enabled, Denial of Service prevention is active for this type of attack. If packets
ingress having TCP flag SYN set and an L4 source port from 0 to 1023, the packets will be
dropped if the mode is enabled.
Default
Format dos-control tcpsyn
Mode
no dos-control tcpsyn
This command sets disables TCP SYN and L4 source = 0-1023 Denial of Service protection.
Format no dos-control tcpsyn
Mode
Global Config
disabled
Global Config
Global Config
disabled
Global Config
Global Config