Querier Status
Querier IP
Address
Querier Up Time
Querier Expiry
Time
Wrong Version
Queries
Number of
Joins
Number of
Groups
IP Multicast Commands
345
ProSafe Managed Switch
IGMP Proxy Commands
The IGMP Proxy is used by IGMP Router (IPv4 system) to enable the system to issue IGMP
host messages on behalf of hosts that the system discovered through standard IGMP router
interfaces. With IGMP Proxy enabled, the system acts as proxy to all the hosts residing on its
router interfaces.
ip igmp-proxy
This command enables the IGMP Proxy on the router. To enable the IGMP Proxy on the
router, you must enable multicast forwarding. Also, make sure that there are no multicast
routing protocols enabled on the router.
Format ip igmp-proxy
Mode
no ip igmp-proxy
This command disables the IGMP Proxy on the router.
Format no ip igmp-proxy
Mode
Term Definition
The status of the IGMP router, whether it is running in Querier mode or Non-Querier
mode.
The IP address of the IGMP Querier on the IP subnet to which this interface is attached.
The time since the interface Querier was last changed.
The amount of time remaining before the Other Querier Present Timer expires. If the
local system is the querier, the value of this object is zero.
The number of queries received whose IGMP version does not match the IGMP version
of the interface.
The number of times a group membership has been added on this interface.
The current number of membership entries for this interface.
Interface Config
Interface Config
To Next Page
Loading...
Need help?
General