Quality of Service (QoS) Commands
442
ProSafe Managed Switch
no cos-queue min-bandwidth
This command restores the default for each queue's minimum bandwidth value.
Format no cos-queue min-bandwidth
Modes
• Global Config
• Interface Config
cos-queue strict
This command activates the strict priority scheduler mode for each specified queue.
Format cos-queue strict <queue-id-1> [<queue-id-2> … <queue-id-n>]
Modes
• Global Config
• Interface Config
no cos-queue strict
This command restores the default weighted scheduler mode for each specified queue.
Format no cos-queue strict <queue-id-1> [<queue-id-2> … <queue-id-n>]
Modes
• Global Config
• Interface Config
cos-queue random-detect
This command activates weighted random early discard (WRED) for each specified queue on
the interface. Specific WRED parameters are configured using the randomdetect
queue-parms and the random-detect exponential-weighting-constant commands. When
specified in Interface Config' mode, this command affects a single interface only, whereas in
Global Config mode, it applies to all interfaces. At least one, but no more than n, queue-id
values are specified with this command.
Duplicate queue-id values are ignored. Each queue-id value ranges from 0 to (n-1), where n
is the total number of queues supported per interface. The number n is platform dependant
and corresponds to the number of supported queues (traffic classes).
Format cos-queue random-detect queue-id-1 [queue-id-2 … queue-id-n]
Modes
• Global Config
• Interface Config
To Next Page
Loading...
