IP Multicast Commands
340
ProSafe Managed Switch
no ip igmp query-interval
This command resets the query interval for the specified interface to the default value. This is
the frequency at which IGMP Host-Query packets are transmitted on this interface.
Format no ip igmp query-interval
Modes
ip igmp query-max-response-time
This command configures the maximum response time interval for the specified interface,
which is the maximum query response time advertised in IGMPv2 queries on this interface.
The time interval is specified in tenths of a second. The range for <maxresptime> is 0 to
255 tenths of a second.
Default
Format ip igmp query-max-response-time <seconds>
Mode
no ip igmp query-max-response-time
This command resets the maximum response time interval for the specified interface, which
is the maximum query response time advertised in IGMPv2 queries on this interface to the
default value. The maximum response time interval is reset to the default time.
Format no ip igmp query-max-response-time
Mode
ip igmp robustness
This command configures the robustness that allows tuning of the interface. The robustness
is the tuning for the expected packet loss on a subnet. If a subnet is expected to have a lot of
loss, the Robustness variable may be increased for the interface. The range for
<robustness> is 1 to 255.
Default
Format ip igmp robustness <robustness>
Mode
no ip igmp robustness
This command sets the robustness value to default.
Format no ip igmp robustness
Mode
Interface Config
100
Interface Config
Interface Config
2
Interface Config
Interface Config
To Next Page
Loading...
Need help?
General