Routing Commands
267
ProSafe Managed Switch
no area virtual-link hello-interval
This command configures the default hello interval for the OSPF virtual interface on the
virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is
the Router ID of the neighbor.
Format no area <areaid> virtual-link <neighbor> hello-interval
Mode
area virtual-link retransmit-interval (OSPF)
This command configures the retransmit interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor. The range for seconds is 0 to 3600.
Default
Format area <areaid> virtual-link <neighbor> retransmit-interval <seconds>
Mode
no area virtual-link retransmit-interval
This command configures the default retransmit interval for the OSPF virtual interface on the
virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is
the Router ID of the neighbor.
Format no area <areaid> virtual-link <neighbor> retransmit-interval
Mode
area virtual-link transmit-delay (OSPF)
This command configures the transmit delay for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor. The range for seconds is 0 to 3600 (1 hour).
Default
Format area <areaid> virtual-link <neighbor> transmit-delay <seconds>
Mode
Format area <areaid> virtual-link <neighbor> hello-interval <1-65535>
Mode
Router OSPF Config
Router OSPF Config
5
Router OSPF Config
Router OSPF Config
1
Router OSPF Config
To Next Page
Loading...
