Quality of Service (QoS) Commands
449
ProSafe Managed Switch
Note: The class-map-name default is reserved and must not be used.
The class type of match-all indicates all of the individual match conditions must be true for
a packet to be considered a member of the class. This command may be used without
specifying a class type to enter the Class-Map Config mode for an existing DiffServ class.
Note: The optional keywords [{ipv4 | ipv6}] specify the Layer 3
protocol for this class. If not specified, this parameter defaults to
ipv4. This maintains backward compatibility for configurations
defined on systems before IPv6 match items were supported.
Note: The CLI mode is changed to Class-Map Config or Ipv6-Class-Map
Config when this command is successfully executed depending on
the [{ipv4 | ipv6}] keyword specified.
no class-map
This command eliminates an existing DiffServ class. The <class-map-name> is the name
of an existing DiffServ class. (The class name ‘default’ is reserved and is not allowed here.)
This command may be issued at any time; if the class is currently referenced by one or more
policies or by any other class, the delete action fails.
Format no class-map <class-map-name>
Mode
class-map rename
This command changes the name of a DiffServ class. The <class-map-name> is the
name of an existing DiffServ class. The <new-class-map-name> parameter is a
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the class.
Default
Format class-map rename <class-map-name> <new-class-map-name>
Mode
Format class-map match-all <class-map-name> [{ipv4 | ipv6}]
Mode
Global Config
Global Config
none
Global Config
To Next Page
Loading...
