EasyManuals Logo

NETGEAR ProSAFE M7100-24X User Manual

NETGEAR ProSAFE M7100-24X
776 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #171 background imageLoading...
Page #171 background image
Switching Commands
171
ProSafe Managed Switch
show port-security
This command displays the port-security settings. If you do not use a parameter, the
command displays the settings for the entire system. Use the optional parameters to display
the settings on a specific interface or on all interfaces.
Format show port-security [{<unit/slot/port> | all}]
Mode
Admin Mode
For each interface, or for the interface you specify, the following information appears:
Admin Mode
Dynamic Limit
Static Limit
Violation Trap
Mode
show port-security dynamic
This command displays the dynamically locked MAC addresses for the port.
Format show port-security dynamic [lag <lag-intf-num> | <unit/slot/port>]
Mode
MAC Address
show port-security static
This command displays the statically locked MAC addresses for port.
Format show port-security static [lag <lag-intf-num> | <unit/slot/port>]
Mode
MAC Address
Privileged EXEC
Term Definition
Port Locking mode for the entire system. This field displays if you do not supply any
parameters.
Term Definition
Port Locking mode for the Interface.
Maximum dynamically allocated MAC Addresses.
Maximum statically allocated MAC Addresses.
Whether violation traps are enabled.
Privileged EXEC
Term Definition
MAC Address of dynamically locked MAC.
Privileged EXEC
Term Definition
MAC Address of statically locked MAC.

Table of Contents

Other manuals for NETGEAR ProSAFE M7100-24X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR ProSAFE M7100-24X and is the answer not in the manual?

NETGEAR ProSAFE M7100-24X Specifications

General IconGeneral
BrandNETGEAR
ModelProSAFE M7100-24X
CategorySwitch
LanguageEnglish

Related product manuals