Management Commands
651
ProSafe Managed Switch
Default Uses the listed authentication methods that follow this argument as the default list of
methods when a user accesses a higher privilege level.
list-name Character string used to name the list of authentication methods activated when a
user accesses a higher privilege level. Up to 12 characters.
method1 [method2…] At least one from the following table:
deny
enable
line
none
radius
tacacs
Note: If the default list is not set, only the enable password is checked.
This has the same effect as the following command:
aaa authentication enable default enable
On the console, the enable password is used if it exists. If no
password is set, the process will succeed anyway. This has the
same effect as the following command:
aaa authentication enable default enable none
no aaa authentication enable
Use this command to remove the authentication method.
Format no aaa authentication enable {default | list-name} method1
[method2...]
Mode
aaa authentication dot1x
Use this command to set authentication for dot1x users. The method argument identifies the
list of methods that the authentication algorithm tries, in the given sequence. The additional
methods of authentication are used only if the previous method returns an error, not if there is
an authentication failure. To ensure that the authentication succeeds even if all methods
return an error, specify
none as the final method in the command line. For example if none is
Keyword Description
Use to deny access.
Uses the enable password for authentication.
Uses the line password for authentication.
Uses no authentication.
Uses the list of all RADIUS servers for authentication. Uses username
"$enabx$."where x is the privilege level.
Uses the list of all TACACS servers for authentication. Uses username
"$enabx$." where x is the privilege level.
Global Config
To Next Page
Loading...
Need help?
General