Interface
Media Type
STP Mode
Physical Mode
Physical Status
Link Status
Loop Status
Partner Flow
Control
Switching Commands
27
ProSafe Managed Switch
Loopback Interface Commands
The commands in this section describe how to create, delete, and manage loopback
interfaces. A loopback interface is always expected to be up. This interface can provide the
source address for sent packets and can receive both local and remote packets. The
loopback interface is typically used by routing protocols.
To assign an IP address to the loopback interface, see ip address on page 224. To assign an
IPv6 address to the loopback interface, see ipv6 address on page 355.
interface loopback
Use this command to enter the Interface Config mode for a loopback interface. The range of
the loopback ID is 0 to 7.
Format interface loopback <loopback-id>
Mode
no interface loopback
This command removes the loopback interface and associated configuration parameters for
the specified loopback interface.
Format no interface loopback <loopback-id>
Mode
Term Definition
Valid slot and port number separated by forward slashes.
“Copper” or “Fiber” for combo port.
Indicate the spanning tree mode of the port.
Either “Auto” or fixed speed and duplex mode.
The actual speed and duplex mode.
Whether the link is Up or Down.
Whether the port is in loop state or not.
Whether the remote side is using flow control or not.
Global Config
Global Config
To Next Page
Loading...
Need help?
General