IPv6 Commands
358
ProSafe Managed Switch
ipv6 mtu
This command sets the maximum transmission unit (MTU) size, in bytes, of IPv6 packets on
an interface. This command replaces the default or link MTU with a new MTU value.
Note:
The default MTU value for a tunnel interface is 1480. You cannot
change this value
.
no ipv6 mtu
This command resets maximum transmission unit value to default value.
Format no ipv6 mtu
Mode
ipv6 nd dad attempts
This command sets the number of duplicate address detection probes transmitted. Duplicate
address detection verifies that an IPv6 address on an interface is unique.
Default
Format ipv6 nd dad attempts <0 - 600>
Mode
no ipv6 nd dad attempts
This command resets to number of duplicate address detection value to default value.
Format no ipv6 nd dad attempts
Mode
Default
0 or link speed (MTU value (1500))
Format ipv6 mtu <1280-1500>
Mode
Interface Config
Interface Config
1
Interface Config
Interface Config
To Next Page
Loading...
Need help?
General