EasyManuals Logo

NETGEAR ProSAFE M7100-24X User Manual

NETGEAR ProSAFE M7100-24X
776 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #723 background imageLoading...
Page #723 background image
Log Messages
723
ProSafe Managed Switch
O/S Support
OS
USL: failed to sync L3 Route table on unit=
x
Could not synchronize unit x due to a
transport failure or API issue on remote
unit. A synchronization retry will be issued
OS
USL: failed to sync initiator table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote
unit. A synchronization retry will be issued
OS
USL: failed to sync terminator table on
unit=x
Could not synchronize unit x due to a
transport failure or API issue on remote
unit. A synchronization retry will be issued
OS
USL: failed to sync ip-multicast table on
unit=x
Could not synchronize unit x due to a
transport failure or API issue on remote
unit. A synchronization retry will be issued
Table 55. OSAPI Log Messages
Component Message Cause
OSAPI
ftruncate failed – File resides on a
read-only file system.
ftruncate is called to correctly set the file’s
size in the file system after a write. The file
system is R/W so this msg indicates the file
system may be corrupted.
OSAPI
ftruncate failed – File is open for reading
only.
ftruncate is called to correctly set the file’s
size in the file system after a write. The file
is opened for R/W so this msg indicates the
file system may be corrupted.
OSAPI
ftruncate failed – File descriptor refers to a
file on which this operation is impossible.
ftruncate is called to correctly set the file’s
size in the file system after a write. This
msg indicates the file system may be
corrupted.
OSAPI
ftruncate failed – Returned an unknown
code in errno.
ftruncate is called to correctly set the file’s
size in the file system after a write. This
msg indicates the file system may be
corrupted.
OSAPI
ping: bad host! The address requested to ping can not be
converted to an Internet address.
OSAPI
osapiTaskDelete: Failed for (XX) error YYY The requested task can not be deleted
because: the requested deletion is called
from an ISR, the task is already deleted, or
the task ID is invalid.
Table 54. System General Error Messages
Component Message Cause

Table of Contents

Other manuals for NETGEAR ProSAFE M7100-24X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR ProSAFE M7100-24X and is the answer not in the manual?

NETGEAR ProSAFE M7100-24X Specifications

General IconGeneral
BrandNETGEAR
ModelProSAFE M7100-24X
CategorySwitch
LanguageEnglish

Related product manuals