NETGEAR ProSAFE M7100-24X User Manual

Switching Commands
24
ProSafe Managed Switch
no shutdown
This command enables a port.
Format no shutdown
Mode
shutdown all
This command disables all ports.
Note: You can use the shutdown all command on physical and
port-channel (LAG) interfaces, but not on VLAN routing interfaces.
no shutdown all
This command enables all ports.
Format no shutdown all
Mode
speed
This command sets the speed and duplex setting for the interface.
Format speed {<100 | 10> <half-duplex | full-duplex>}
Mode
Format shutdown
Mode
Interface Config
Interface Config
Format shutdown all
Mode
Global Config
Global Config
Interface Config
Acceptable
Values
Definition
100h
100BASE-T half duplex
100f
100BASE-T full duplex

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English