Utility Commands
539
ProSafe Managed Switch
security
Use this command to set the email alerting security protocol by enabling the switch to use
TLS authentication with the SMTP Server. If the TLS mode is enabled on the switch but the
SMTP sever does not support TLS mode, no email is sent to the SMTP server.
Default
Format security {tlsv1 | none}
Mode
port
Use this command to configure the TCP port to use for communication with the SMTP server.
The recommended port for TLSv1 is 465, and for no security (i.e. none) it is 25. However, any
nonstandard port in the range 1 to 65535 is also allowed.
Default
Format port {465 | 25 | 1–65535}
Mode
username
Use this command to configure the login ID that the switch uses to authenticate with the
SMTP server.
Default
Format username name
Mode
password
Use this command to configure the password that the switch uses to authenticate with the
SMTP server.
Format password password
Mode
show mail-server config
Use this command to display information about the email alert configuration.
Format show mail-server {ip-address | hostname | all } config
Mode
none
Mail Server Config
25
Mail Server Config
admin
Mail Server Config
Mail Server Config
Privileged EXEC
To Next Page
Loading...
Need help?
General