NETGEAR ProSAFE M7100-24X - Show Lldp Med; Show Lldp Med Interface

Switching Commands
184
ProSafe Managed Switch
no lldp med transmit-tlv
Use this command to remove a TLV.
Format no lldp med transmit-tlv all [capabilities] [network-policy] [ex-pse]
[ex-pd] [location] [inventory]
Mode
show lldp med
Use this command to display a summary of the current LLDP MED configuration.
Format show lldp med
Mode
Example: The following shows example CLI display output for the command.
(switch) #show lldp med
LLDP MED Global Configuration
Fast Start Repeat Count: 3
Device Class: Network Connectivity
(switch) #
show lldp med interface
Use this command to display a summary of the current LLDP MED configuration for a specific
interface.
<unit/slot/port> indicates a specific physical interface. all indicates all valid
LLDP interfaces.
Format show lldp med interface {<unit/slot/port> | all}
Mode
Global Config
Privileged Exec
Term Definition
Fast Start
Repeat Count
The number of LLDP PDUs that will be transmitted when the protocol is enabled.
Device Class
The local device’s MED Classification. There are four different kinds of devices, three of
them represent the actual end points (classified as Class I Generic[IP Communication
Controller etc.], Class II Media Conference Bridge etc.], Class III Communication [IP
Telephone etc.]. Class IV Network Connectivity Device, which is typically a LAN Switch,
Router, IEEE 802.11 Wireless Access Point, etc.
Privileged Exec