Switching Commands
204
ProSafe Managed Switch
show isdp interface
This command displays ISDP settings for the specified interface.
Format show isdp interface {all | <unit/slot/port>}
Mode
Mode
show isdp entry
This command displays ISDP entries. If the device id is specified, then only entries for that
device are shown.
Format show isdp entry {all | deviceid}
Mode
Device ID
The Device ID advertised by this device. The format of this Device ID is characterized by
the value of the Device ID Format object.
Device ID
Format
Capability
Indicates the Device ID format capability of the device.
• serialNumber indicates that the device uses a serial number as the format for its
Device ID.
• macAddress indicates that the device uses a Layer 2 MAC address as the format for
its Device ID.
• other indicates that the device uses its platform-specific format as the format for its
Device ID.
Device ID
Format
Indicates the Device ID format of the device.
• serialNumber indicates that the value is in the form of an ASCII string containing the
device serial number.
• macAddress indicates that the value is in the form of a Layer 2 MAC address.
• other indicates that the value is in the form of a platform specific ASCII string
containing info that identifies the device. For example, ASCII string contains
serialNumber appended/prepended with system name.
Privileged EXEC
Term Definition
ISDP mode enabled/disabled status for the interface(s).
Privileged EXEC
Term Definition
Device ID
The device ID associated with the neighbor which advertised the information.
IP Addresses
The IP address(es) associated with the neighbor.
Platform
The hardware platform advertised by the neighbor.
Interface
The interface (slot/port) on which the neighbor's advertisement was received.
Port ID
The port ID of the interface from which the neighbor sent the advertisement.
Term Definition
To Next Page
Loading...
Need help?
General