IPv6 Commands
361
ProSafe Managed Switch
ipv6 nd reachable-time
This command sets the router advertisement time to consider a neighbor reachable after
neighbor discovery confirmation. Reachable time is specified in milliseconds. A value of zero
means the time is unspecified by the router.
Default
Format ipv6 nd reachable-time <0–3600000>
Mode
no ipv6 nd reachable-time
This command means reachable time is unspecified for the router.
Format no ipv6 nd reachable-time
Mode
ipv6 nd suppress-ra
This command suppresses router advertisement transmission on an interface.
Default
Format ipv6 nd suppress-ra
Mode
no ipv6 nd suppress-ra
This command enables router transmission on an interface
.
Format no ipv6 nd suppress-ra
Mode
ipv6 nd router-preference
This is used to configure router preference value in IPv6 router advertisements on an
interface. This will indicate whether or not to prefer this router over other default routers.
Default Medium
Format ipv6 nd router-preference <high/low/medium>
Mode
0
Interface Config
Interface Config
disabled
Interface Config
Interface Config
Interface Config
To Next Page
Loading...
Need help?
General