Routing Commands
274
ProSafe Managed Switch
authentication key must be 8 bytes or less if the authentication type is simple. If the type is
encrypt, the key may be up to 16 bytes. If the type is encrypt a <keyid> in the range of 0 and
255 must be specified. Unauthenticated interfaces do not need an authentication key or
authentication key ID. There is no default value for this command.
Format ip ospf authentication {none | {simple <key>} | {encrypt <key>
<keyid>}}
Mode
no ip ospf authentication
This command sets the default OSPF Authentication Type for the specified interface.
Format no ip ospf authentication
Mode
ip ospf cost
This command configures the cost on an OSPF interface. The <cost> parameter has a
range of 1 to 65535.
Default
Format ip ospf cost <1-65535>
Mode
no ip ospf cost
This command configures the default cost on an OSPF interface.
Format no ip ospf cost
Mode
ip ospf database-filter all out
Use this command in Interface Configuration mode to disable OSPFv2 LSA flooding on an
interface.
Default
Format
ip ospf database-filter all out
Mode
Interface Config
Interface Config
10
Interface Config
Interface Config
Disabled
Interface Configuration
To Next Page
Loading...
Need help?
General