Switching Commands
155
ProSafe Managed Switch
The IGMP Snooping Querier application supports sending periodic general queries on the
VLAN to solicit membership reports.
Default
Format set igmp querier [<vlan-id>] [address ipv4_address]
Mode
• Global Config
• VLAN Mode
no set igmp querier
Use this command to disable IGMP Snooping Querier on the system. Use the optional
address parameter to reset the querier address to 0.0.0.0.
Format no set igmp querier [<vlan-id>] [address]
Mode
• Global Config
• VLAN Mode
set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time. It is the amount of time in
seconds that the switch waits before sending another general query.
Default
Format set igmp querier query-interval <1-18000>
Mode
no set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time to its default value.
Format no set igmp querier query-interval
Mode
set igmp querier timer expiry
Use this command to set the IGMP Querier timer expiration period. It is the time period that
the switch remains in Non-Querier mode once it has discovered that there is a Multicast
Querier in the network.
Default
Format set igmp querier timer expiry <60-300>
Mode
disabled
disabled
Global Config
Global Config
60 seconds
Global Config
To Next Page
Loading...
