Routing Commands
263
ProSafe Managed Switch
of candidate causes the router to participate in the translator election process when it
attains border router status.
Format area <areaid> nssa translator-role {always | candidate}
Mode
no area nssa translator-role (OSPF)
This command disables the nssa translator role from the specified area id.
Format no area <areaid> nssa translator-role {always | candidate}
Mode
area nssa translator-stab-intv (OSPF)
This command configures the translator <stabilityinterval> of the NSSA. The
<stabilityinterval> is the period of time that an elected translator continues to perform
its duties after it determines that its translator status has been deposed by another router.
Format area <areaid> nssa translator-stab-intv <stabilityinterval>
Mode
no area nssa translator-stab-intv (OSPF)
This command disables the nssa translator’s <stabilityinterval> from the specified
area id.
Format no area <areaid> nssa translator-stab-intv <stabilityinterval>
Mode
area range (OSPF)
Use this command in Router Configuration mode to configure a summary prefix that an area
border router advertises for a specific area.
Default
Format
area areaid range prefix netmask {summarylink |
nssaexternallink} [advertise | not-advertise] [cost cost]
Mode
Router OSPF Config
Router OSPF Config
Router OSPF Config
Router OSPF Config
No area ranges are configured by default. No cost is configured by default.
OSPFv2 Router Configuration
Parameter Description
area-id The area identifier for the area whose networks are to be summarized.
prefix netmask The summary prefix to be advertised when the ABR computes a route to one or more
networks within this prefix in this area.
To Next Page
Loading...
Need help?
General