Quality of Service (QoS) Commands
452
ProSafe Managed Switch
match destination-address mac
This command adds to the specified class definition a match condition based on the
destination MAC address of a packet. The <macaddr> parameter is any layer 2 MAC
address formatted as six, two-digit hexadecimal numbers separated by colons (e.g.,
00:11:22:dd:ee:ff). The <macmask> parameter is a layer 2 MAC address bit mask, which
need not be contiguous, and is formatted as six, two-digit hexadecimal numbers separated
by colons (e.g., ff:07:23:ff:fe:dc).
Default
Format match destination-address mac <macaddr> <macmask>
Mode
match dstip
This command adds to the specified class definition a match condition based on the
destination IP address of a packet. The <ipaddr> parameter specifies an IP address. The
<ipmask> parameter specifies an IP address bit mask and must consist of a contiguous set
of leading 1 bits.
Default
Format match dstip <ipaddr> <ipmask>
Mode
match dstip6
This command adds to the specified class definition a match condition based on the
destination IPv6 address of a packet.
Default
Format match dstip6 <destination-ipv6-prefix/prefix-length>
Mode
match dstl4port
This command adds to the specified class definition a match condition based on the
destination layer 4 port of a packet using a single keyword or numeric notation. To specify the
match condition as a single keyword, the value for <portkey> is one of the supported port
name keywords. The currently supported <portkey> values are: domain, echo, ftp, ftpdata,
http, smtp, snmp, telnet, tftp, www. Each of these translates into its equivalent port number.
none
Class-Map Config
Ipv6-Class-Map Config
none
Class-Map Config
none
Ipv6-Class-Map Config
To Next Page
Loading...
