Switching Commands
202
ProSafe Managed Switch
no isdp run
This command disables ISDP on the switch.
Format no isdp run
Mode
isdp holdtime
This command configures the hold time for ISDP packets that the switch transmits. The hold
time specifies how long a receiving device should store information sent in the ISDP packet
before discarding it. The range is given in seconds.
Default
Format isdp holdtime <10-255>
Mode
isdp timer
This command sets the period of time between sending new ISDP packets. The range is
given in seconds.
Default
Format isdp timer <5-254>
Mode
isdp advertise-v2
This command enables the sending of ISDP version 2 packets from the device.
Default
Format isdp advertise-v2
Mode
no isdp advertise-v2
This command disables the sending of ISDP version 2 packets from the device.
Format no isdp advertise-v2
Mode
Global Config
180 seconds
Global Config
30 seconds
Global Config
Enabled
Global Config
Global Config
To Next Page
Loading...
Need help?
General