IP Multicast Commands
328
ProSafe Managed Switch
routing across the Internet, independent of the mechanisms provided by any particular
unicast routing protocol.
ip pim dense (Global Config)
This command enables the administrative mode of PIM-DM in the router.
Default
Format ip pim dense
Mode
no ip pim dense (Global Config)
This command disables the administrative mode of PIM-DM in the router.
Format no ip pim dense
Mode
ip pim (Interface Config)
This command sets administrative mode of PIM on an interface to enabled.
Default
Format ip pim
Mode
no ip pim (Interface Config)
This command sets administrative mode of PIM on an interface to disabled.
Format no ip pim
Mode
ip pim hello-interval
This command configures the transmission frequency of PIM Hello messages between PIM
enabled neighbors. This field has a range of 0 to 18000 seconds.
Default
Format ip pim hello-interval <0-18000>
Mode
Disabled
Global Config
Global Config
disabled
Interface Config
Interface Config
30
Interface Config
To Next Page
Loading...
