Switching Commands
161
ProSafe Managed Switch
no set mld maxresponse
Use this command to set the max response time (on the interface or VLAN) to the default
value.
Format no set mld maxresponse
Mode
• Global Config
• Interface Config
• VLAN Mode
set mld mcrtexpiretime
Use this command to set the Multicast Router Present Expiration time. The time is set for the
system, on a particular interface or VLAN. This is the amount of time in seconds that a switch
waits for a query to be received on an interface before the interface is removed from the list of
interfaces with multicast routers attached. The range is 0 to 3600 seconds. A value of 0
indicates an infinite timeout, that is, no expiration.
Default
Format set mld mcrtexpiretime
vlanid 0-3600
Mode
• Global Config
• Interface Config
no set mld mcrtexpiretime
Use this command to set the Multicast Router Present Expiration time to 0. The time is set for
the system, on a particular interface or a VLAN.
Format no set mld mcrtexpiretime vlanid
Mode
• Global Config
• Interface Config
set mld mrouter
Use this command to configure the VLAN ID for the VLAN that has the multicast router
attached mode enabled.
Format set mld mrouter vlanid
Mode
0
Interface Config
To Next Page
Loading...
