Switching Commands
205
ProSafe Managed Switch
show isdp neighbors
This command displays the list of neighboring devices.
Format show isdp neighbors [ {<unit/slot/port> | detail} ]
Mode
Example: The following shows example CLI display output for the command.
(Switch) #show isdp neighbors detail
Device ID 0001f45f1bc0
Address(es):
IP Address: 10.27.7.57
Capability Router Trans Bridge Switch IGMP
Platform SecureStack C2
Interface 0/48
Port ID ge.3.14
Holdtime 131
Advertisement Version 2
Entry last changed time 0 days 00:01:59
Version : 05.00.56
Hold Time
The hold time advertised by the neighbor.
Version
The software version that the neighbor is running.
Advertisement
Version
The version of the advertisement packet received from the neighbor.
Capability
ISDP Functional Capabilities advertised by the neighbor.
Privileged EXEC
Term Definition
Device ID
The device ID associated with the neighbor which advertised the information.
IP Addresses
The IP addresses associated with the neighbor.
Capability
ISDP functional capabilities advertised by the neighbor.
Platform
The hardware platform advertised by the neighbor.
Interface
The interface (unit/slot/port) on which the neighbor's advertisement was received.
Port ID
The port ID of the interface from which the neighbor sent the advertisement.
Hold Time
The hold time advertised by the neighbor.
Advertisement
Version
The version of the advertisement packet received from the neighbor.
Entry Last
Changed Time
Displays when the entry was last modified.
Version
The software version that the neighbor is running.
Term Definition
To Next Page
Loading...
