NETGEAR ProSAFE M7100-24X - Show Captive-Portal Configuration Status

Captive Portal Commands
737
ProSafe Managed Switch
If the interface is specified. The following term will be displayed.
Authenticated
users
Example
(Switch)#show captive-portal configuration 1 interface
CP ID..................................... 1
CP Name................................... cp1
Operational Block
Interface Interface Description Status Status
--------- --------------------- ---------------- ----------1/0/1
Unit:1Slot:0Port:1 Disabled Blocked
(Switch)#show captive-portal configuration 1 interface 1/0/1
CP ID..................................... 1
CP Name................................... cp1
Interface................................. 1/0/1
Interface Description..................... Unit: 1 Slot: 0 Port: 1 Gigab
Operational Status........................ Disabled
Disable Reason............................ Interface Not Attached
Block Status.............................. Not Blocked
Authenticated Users....................... 0
show captive-portal configuration status
Use this command to display information about all configured captive portal configurations or
about a specific captive portal configuration. The <1-10> is captive portal ID. If <1-10> is not
entered, all the configurations are displayed.
Format show captive-portal configuration [ <1-10> ] status
Mode
CP ID
CP Name
Mode
Protocol Mode
Verification Mode
Term Definition
The number of authenticated users associated with the CP ID.
Privileged EXEC mode
Term Definition
The captive portal instance ID
The captive portal instance name
The operational mode is enabled or disabled.
The protocol mode is https or http.
The user verification mode has three modes: guest, local and radius. The default is
guest mode.