NETGEAR ProSAFE M7100-24X User Manual

Utility Commands
508
ProSafe Managed Switch
Auto Install Commands
This section describes the Auto Install Commands. Auto Install is a software feature which
provides for the configuration of a switch automatically when the device is initialized and no
configuration file is found on the switch. The Auto Install process requires DHCP to be
enabled by default in order for it to be completed. The downloaded config file is not
automatically saved to startup-config. An administrator must explicitly issue a save request in
order to save the configuration. The Auto Install process depends upon the configuration of
other devices in the network, including a DHCP or BOOTP server, a TFTP server and, if
necessary, a DNS server.
There are three steps to Auto Install:
1. Configuration or assignment of an IP address for the device.
2. Assignment of a TFTP server.
3. Obtain a configuration file for the device from the TFTP server.
show autoinstall
This command displays the current status of the Auto Config process.
Format show autoinstall
Mode
AutoInstall
Mode
AutoSave
Modet
AutoInstall
Retry Count
AutoInstall
State
Example
(switch) #show autoinstall
AutoInstall Mode............................... Stopped
AutoSave Mode.................................. Disabled
AutoInstall Persistant Mode.................... Enabled
AutoInstall Retry Count........................ 3
AutoInstall State.............................. Waiting for boot options
Privileged EXEC
Term Definition
The administrator mode is enabled or disabled.
If this option is enabled, the downloaded config file will be saved. Otherwise,
administrator must explicitly issue a "copy running-config startup-config" command in
order to save the configuration.
the number of attempts to download a configuration.
The status of the AutoInstall.

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English